MEASUREMENT GUIDE
Please read the below measuring guides to ensure you order the correct size.

Belt Measuring
-
Take your existing belt and lay it on a flat surface
-
Using a measuring tape or long ruler, measure from the leather fold (not including buckle) to the hole most used
-
Either use centimetres or inches
-
If you do not have a belt to take measurements from please use a tape measure and measure around your waist (with clothes on) where your belt will sit.

Dog Collar Measuring
-
Dog collars are best measured from the internal length of the existing collar
-
Remove your dog’s collar and lay it on a flat table
-
Using a flexible tape measure, measure from the leather fold (not including buckle) to the hole most used.
-
Then check this measurement by measuring around your dog’s neck where the collar is worn and at the same looseness as the collar
-
Make sure to put two fingers inside the measuring tape as collars are not supposed to be worn too tight on a dog
-
If you do not have a collar to measure from then measure around your dogs neck where the collar will sit and at the looseness you require.
-
Make sure to fit two fingers under the tape measure
-
The measurement given will be the center hole with 2 holes either side for adjustment